LLooaaddiinngg MMeeddiiaa iinn TTrraayyss 11,, 22,, aanndd 33
Information About Loading Media in Trays 1, 2, and 3
Trays 1, 2, and 3 are identical. Each tray has a capacity of 550 sheets of 20 lb./75 g/m
2
paper. Stock
can be Long Edge Feed (LEF) or Short Edge Feed (SEF), landscape or portrait.
Note: Each feeder tray has a stock loading label. When loading media into the tray, refer to the
labels on the inside panel of the feeder tray for the correct orientation of that stock type.
Loading Paper in Trays 1, 2, and 3
Note: A paper jam may occur if a tray is opened while it is being used to feed stock.
1. Select the appropriate paper stock for your print or copy job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and align the edge of the paper against the left edge of the tray.
Paper can be loaded in either the LEF/portrait or SEF/landscape direction.
6. Adjust the paper guides by pressing in the guide release and carefully moving the Edge Guide
until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
7. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings/Tray Properties window may be
displayed on the UI. You can view and set stock attributes and verify trays are assigned with the
correct stock.
8. From the Paper Tray settings/Tray Properties window, choose one of the following:
• No changes were made to the paper tray; select Confirm to close the window.
• Changes were made to the paper tray; go to the next step.
9. Select the Change Settings button.
a. Make the desired selections for Paper Type/Paper Weight, Paper Size, and Paper Color.
b. If necessary, make the desired changes to paper curl and alignment adjustment.
c. Select Save until you are returned to the Paper Tray settings/Tray Properties window.
107
To Next Page
Loading...
Need help?
General
