c. When prompted, select Logout.
TTrraayyss 66 aanndd 77 MMaaiinntteennaannccee
Consumable Supplies for Tray 5-9
CRUs (Supply Item) Reorder Quantity
Approximate Print Yield (Full
Color 8.5x11/A4 Prints)
Feed Roll Kit (Trays 5–9) 1 kit 300,000
**Each tray requires its own feed roll kit. Each kit contains all the required items for replacing the feed rolls.
Important: Three feed roll kits are available:
• Reorder number: 008R13196 for Tray 5
• Reorder number: 008R13195 for Tray 6, 1-Tray Oversized High Capacity Feeder
• Reorder number: 008R13169 for Trays 6-9, 2-Tray Advanced Oversized High Capacity Feeder or Dual
Advanced Oversized High Capacity Feeder; 1 roll kit is required for each tray.
For more information, contact the Customer Support Center.
Replacing Tray 5 Feed Rolls
Use this procedure by Tray 5 is installed on top of Trays 6 and 7.
Tip: Replace the bypass tray feed rolls when experiencing frequent multifeeds, single feeds, or
blank prints in the stack of the output prints.
Use this procedure to replace the Bypass tray feed rolls, which includes:
• Feed Roll
• Nudger Roll
• Separator Roll
Note: After you replace all of the feed rolls, contact your system administrator who will reset
the HFSI counter for these CRU components to zero (0).
1. Locate and access the Bypass Tray on top of Trays 6 and 7.
2. Lift up and open the Bypass Tray cover to access the feed roll components.
200
To Next Page
Loading...
Need help?
General
