Loading Paper in the Bypass (Tray 5)
Note: The following procedure shows the Bypass (Tray 5) located on top of the 2-Tray OHCF.
1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the paper.
2. Hold the center of the paper guides and slide them to the desired paper size.
3. Select the appropriate paper stock for your print/copy job.
4. Open the ream of paper with the seam side facing up.
5. Fan the sheets before loading them into the tray.
6. Insert the paper or media into the tray until it stops.
7. Adjust the paper guides so that they touch the edges of the stack.
If enabled by your System Administrator, the Paper Tray settings/Tray Properties window may be
displayed on the UI.
8. If the Paper Tray settings/Tray Properties window displays on the UI, confirm the correct tray to
which it is printing and other information, including size, type (precut tab), and, if necessary,
paper curl and/or alignment option.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray Properties
window.
111
To Next Page
Loading...
Need help?
General
