c. Select System Settings→Common Service Settings→Maintenance.
d. Use the arrow buttons to access the next Maintenance screens.
e. Select the Technical Key Operator (TKO) icon.
The Technical Key Operator feature displays.
f. Log in to the Technical Key Operator mode.
Attention
If you cannot log in as TKO, or do not have the TKO password, call your Customer Service
Engineer.
g. Select the bypass rolls item that corresponds with the newly-replaced components.
h. Select Reset Current Value. The system resets the HFSI to 0.
9. Exit the administrator mode by pressing the Log In/Out button on the UI.
When prompted, select Logout.
Replacing Trays 6 and 7 Feed Rolls
Replace the feed rolls every 300,000 prints or when experiencing frequent multifeeds, single feeds, or
blank prints in the stack of the output prints.
Use this procedure to replace the feed rolls, which includes:
• Feed Roll
• Nudger Roll
202
To Next Page
Need help?
General
