5. While holding the tabs on the new staple cartridge, push in the cartridge until it seats.
Note: Make sure that the marks are aligned.
6. Push the Saddle Stitch Unit 3 gently into the finisher until it stops.
7. Close the finisher front cover.
Stapler Faults in the PR Finisher Plus
Refer to the following procedures for clearing staple jams the PR Finisher Plus, Basic Staple Cartridge:
• Finisher Staple Faults
• Clearing Staple Jams in the Basic Stapler
• Reinserting the Basic Staple Cartridge
Finisher Fault Messages
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops
printing and a message appears on the press touch screen. A graphical illustration shows the location
of the fault with a brief explanation of corrective actions for clearing the fault. If a fault occurs in
more than one location, the illustration changes to indicate the multiple locations and the required
corrective actions.
The touch screen also displays a Faults button which provides information about the fault and
detailed instructions for correcting the fault. The (E) code on the upper-left part of the Fault message
displays which error indicator is lit on the Finisher indicator panel (E1–E9).
Finisher Fault Code Information
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops
printing and a message appears on the press touch screen.
The touch screen also displays a Faults button which provides information about the fault and
detailed instructions for correcting the fault.
365
To Next Page
Loading...
Need help?
General
