Note: After you replace the Dry Ink/Toner Waste Bottle, the system automatically resets the
usage counter to zero (0) for this CRU component. Check the Consumables Supply screen to
verify the reset.
1. Ensure that the press is stopped (not running any jobs).
2. Open the front door of the press.
3. Open the Dry Ink/Toner Waste Bottle Door.
4. Grasp the handle of the Dry Ink/Toner Waste bottle and pull it halfway out of the press.
5. Support the underside of the bottle with your other hand and continue pulling it out from the
press.
Caution: Never use a vacuum cleaner when cleaning up spilled dry ink/toner. Use a broom
or a cloth moistened with a neutral detergent.
6. Use both hands to place the old used Dry Ink/Toner Waste Bottle into the provided plastic bag.
7. Remove a new, empty waste bottle from the packaging.
8. Hold the center part on the top of a new bottle and insert it evenly and gently into the press until
it comes to a stop.
9. Close the waste bottle door.
10. Close the press front door.
194
To Next Page
Loading...
Need help?
General
