Xerox WorkCentre 4260 Series System Administration Guide 111
12 Network Accounting
This chapter explains how to set up the Network Accounting service of the machine.
This is the procedure to follow to install and setup this service:
1. Overview on page 111
2. Information Checklist on page 111
3. Insert the Feature Enablement Key on page 112
4. Configure Network Accounting on page 113
5. Test Network Accounting on page 115
Overview
Network Accounting provides the ability to manage usage of the machine with detailed cost
analysis capabilities. Print, Scan, Server Fax, and copy jobs are tracked at the machine and
stored in a job log. Users must enter their accounting IDs to access the machine, which
allows information about the jobs performed as recorded in a job log.
The machine requires the Feature Enablement Key to be inserted and network access to a
Xerox-certified Network Accounting third party software solution. Refer to your Xerox Sales
Representative for further information.
CentreWare Print and Fax Drivers are required to be installed on workstations. The User is
prompted for User and Account ID information when submitting jobs to the machine.
The job log information can be compiled at the accounting server and formatted into
reports by the Administrator.
Information Checklist
Before starting the Installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. Ensure that the machine is fully functioning on the network prior to installation.
2. Locate the Network Accounting Feature Enablement Key
Contact your Xerox Sales Representative if you do not have the Feature Enablement
Key. This Feature Enablement Key contains the License Agreement and Kit Code
Number to enable the feature.
3. TCP/IP and HTTP protocols must be enabled on the machine so that the machine
web browser can be accessed.
To Next Page
Loading...
Need help?
General
