Xilinx VCK190 Series User Manual

Chapter 2
Board Setup and Configuration
Standard ESD Measures
CAUTION! ESD can damage electronic components when they are improperly handled, and can result in
total or intermient failures. Always follow ESD-prevenon procedures when removing and replacing
components.
To prevent ESD damage:
• Aach a wrist strap to an unpainted metal surface of your hardware to prevent electrostac
discharge from damaging your hardware.
• When you are using a wrist strap, follow all electrical safety procedures. A wrist strap is for
stac control. It does not increase or decrease your risk of receiving electric shock when you
are using or working on electrical equipment.
• If you do not have a wrist strap, before you remove the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of ve seconds.
• Do not remove the device from the anstac bag unl you are ready to install the device in
the system.
• With the device sll in its anstac bag, touch it to the metal frame of the system.
• Grasp cards and boards by the edges. Avoid touching the components and gold connectors on
the adapter.
• If you need to lay the device down while it is out of the anstac bag, lay it on the anstac
bag. Before you pick it up again, touch the anstac bag and the metal frame of the system at
the same me.
• Handle the devices carefully to prevent permanent damage.
Board Component Location
The following gure shows the VCK190 board component locaons. Each numbered component
shown in the gure is keyed to the table in Board Component Descripons.
Chapter 2: Board Setup and Configuration
UG1366 (v1.0) January 7, 2021 www.xilinx.com
VCK190 Board User Guide 13
Send Feedback

Xilinx VCK190 Series Specifications

General

Brand	Xilinx
Model	VCK190 Series
Category	Motherboard
Language	English