Xilinx VCK190 Series User Manual

○ 2-pole DIP SW3[1:2] seng is XX as the MUX is inhibited/turned o
○ In this mode, the FT4232 device (U20) UART funconality connues to be available
○ Power-cycle the VCK190 board or press the power-on reset pushbuon (SW2) (SW2 is
callout 46 in the "Evaluaon Board Component Locaons" gure in Board Component
Locaon)
QSPI32
This boot mode is supported only with boot module X-EBM-01 aached to the MIO connector
(J212). J212 is a 240-pin (8 x 30) MIO connector wired to XCVC1902 U1 bank 500
PMC_MIO[0:12] pins. The supported QSPI conguraons are x1, x2, x4, and dual-parallel x8. To
boot from a QSPI X-EBM-01 boot module:
1. Store a valid XCVC1902 ACAP boot image le on the X-EBM-01 resident QSPI.
2. Set boot mode SW1 for QSPI32 as indicated in the "Mode Switch SW1 Conguraon Opon
Sengs" table in Versal ACAP Conguraon.
3. Power-cycle the VCK190 or press the POR pushbuon SW2. SW2 is callout 35 in the
"Evaluaon Board Component Locaons" gure in Board Component Locaon.
SD1_3.0
To boot from a SD card installed in microSD card socket J302:
1. Store a valid XCVC1902 ACAP boot image le on a microSD card. Plug the SD card into the
VCK190 board SD socket J302 connected to the XCVC1902 U1 bank 501 MIO SD interface.
2. Set boot MODE SW1 for SD1_3.0 as indicated in the "Mode Switch SW1 Conguraon
Opon Sengs" table in Versal ACAP Conguraon.
3. Power-cycle the VCK190 or press the POR pushbuon SW2. SW2 is callout 35 in the
"Evaluaon Board Component Locaons" gure in Board Component Locaon.
Chapter 2: Board Setup and Configuration
UG1366 (v1.0) January 7, 2021 www.xilinx.com
VCK190 Board User Guide 22
Send Feedback

Xilinx VCK190 Series Specifications

General

Brand	Xilinx
Model	VCK190 Series
Category	Motherboard
Language	English