BASIC USES OF Σ-SERIES PRODUCTS
2.3.3 Examples of Connecting I/O Signal Terminals
30
2.3.3 Examples of Connecting I/O Signal Terminals
1) This sub-section provides typical examples of connecting to main host controllers. Con-
nection to other host controllers is also possible. Connect to the host controller according
to the connection examples shown below by referring to technical documentation for the
host controller.
NOTE This sub-section describes signals related to the SGDA Servopack only. For other sig-
nals, refer to the relevant technical documentation.
2) Example of Connecting to PROGIC-8
Servopack for Speed/Torque Control
Yaskawa
MC unit
(Reserved)
FG (connector frame)
*1 These pin numbers are also applicable to SV2 to SV4.
*2 Do not change the standard settings of user constants for the Servopack.
Servopack
Not used
2
SGDA-jjj S
Speed/Torque
To Next Page
Loading...
Need help?
General
