Administrator’s Guide for SIP-T5 Series Smart Media Phones
186
7. Click Confirm to accept the change.
To configure the NTP server and time zone via phone user interface:
1. Tap Settings->Basic->Time & Date->Type.
2. Tap the Type field.
3. Tap SNTP Settings in the pop-up dialog box.
4. Tap the Time Zone field.
5. Tap the time zone that applies to your area in the pop-up dialog box.
6. Enter the domain name or IP address of SNTP server in the NTP Server1 and NTP Server2
field respectively.
7. Tap the Daylight Saving field.
8. Tap the desired value in the pop-up dialog box.
9. Tap the Location field.
This field appears only if Daylight Saving field is selected to Automatic.
10. Tap the desired time zone name in the pop-up dialog box.
11. Tap to accept the change.
Time and Date Settings
You can set the time and date manually when IP phones cannot obtain the time and date from
the NTP time server. The time and date display can use one of several different formats.
Procedure
Time and date can be configured using the following methods.
Central Provisioning
(Configuration File)
Configure the time and date manually.
Parameter:
local_time.manual_time_enable
Configure the time and date formats.
Parameters:
local_time.time_format
local_time.date_format
Configure the time and date manually.
Configure the time and date formats.
Navigate to:
http://<phoneIPAddress>/servlet?m=m
od_data&p=settings-datetime&q=load
Configure the time and date manually.
Configure the time and date formats.
To Next Page
Loading...
Need help?
General
