Introduction
ix
Configuration Parameter Table Format
The following configuration parameter table describes the parameter that you can configure to
make the feature (e.g., auto answer) work.
Note
The above table also indicates three methods for configuring the feature.
Method 1: Central Provisioning
This table specifies the details of
account.X.auto_answer
parameter, which enables or disables
the auto answer feature. This parameter is disabled by default. If you want to enable the auto
answer feature, open the MAC.cfg file and locate the parameter name
account.X.auto_answer
.
Set the parameter value to “1” to enable the auto answer feature or “0” to disable the auto
answer feature.
Note that some parameters described in this guide contain one or more variables (e.g., X or Y).
But the variables in the parameters described in the CFG file are all replaced with specific value
in the scope of variable. You may need to assign a value to the variable before you search and
locate the specific parameter in the CFG file.
For example, if you want to enable the auto answer feature for account 1, you need to locate the
account.1.auto_answer
in the MAC.cfg file and then configure it as required (e.g.,
account.1.auto_answer = 1). If you want to enable the audio codec 1 for account 1, you can
Sometimes you will see the words “Refer to the following content” in the Permitted Values or
Default field. It means the permitted value or the default value of the parameter has the model
difference or there are many permitted values of the parameter, you can get more details from
the following Description field.
The word “None” in the Web User Interface or Phone User Interface field means this feature
cannot be configurable via web/phone user interface.
To Next Page
Loading...
Need help?
General
