Administrator’s Guide for SIP-T5 Series Smart Media Phones
36
To configure PPPoE via web user interface:
1. Click on Network->Basic.
2. In the IPv4 Config block, mark the PPPoE radio box.
3. Enter the user name and password in corresponding fields.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the phone.
To configure PPPoE via phone user interface:
1. Tap Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Tap the Type field.
3. Tap PPPoE in the pop-up dialog box.
4. Enter the user name and password in corresponding fields.
5. Tap to accept the change.
The phone prompts you to reboot the phone.
6. Tap OK to reboot the phone.
The settings will take effect after a reboot.
Configuring Transmission Methods of the Internet Port and PC
Port
Yealink IP phones support two Ethernet ports: Internet port and PC port. You can enable or
disable the PC port on the IP phones. Three optional methods of transmission configuration for
IP phone Internet port or PC port:
Auto-negotiate
To Next Page
Need help?
General
