dvanced Guide
>
Troubleshooting
> Print Head Holder Does Not Move to the Position for Replacing
Print Head Holder Does Not Move to the Position for Replacing
Check 1: Is the
Power
lamp off?
Check if the
Power lamp is lit green.
The Print Head Holder will not move unless the power is on. If the Power lamp is off, close the Top
Cover and turn the printer on.
While the
Power
lamp is flashing green, the printer is initializing. Wait until the
Power
lamp stops
flashing and remains lit green, and then open the Top Cover again.
Check 2: Is the
Alarm
lamp flashing?
Close the Top Cover, confirm the number of times the
Alarm
lamp is flashing, take the appropriate
action to resolve the error, and then reopen it. For details on how to resolve the error, see
larm
Lamp Flashes Orange
.
Check 3: Has the Top Cover been left open for 10 minutes or longer?
If the Top Cover is left open for more than 10 minutes, the Print Head Holder moves to the right to
prevent the Print Head from drying out. Close and reopen the Top Cover to return the Print Head
Holder to the center.
Check 4: Has the printer been printing continuously for a long period?
If the printer has been printing continuously for a long time, close the Top Cover, wait a while, then
reopen it.
If the printer has been printing continuously for a long time, the Print Head Holder may not move to
the center since the Print Head may overheat.
Note
Opening the Top Cover while printing moves the Print Head Holder to the right. Close the Top
Cover, and reopen it after printing finishes.
Page top
Стр. 322 из 366 стр.Print Head Holder Does Not Move to the Position for Replacing
To Next Page
Loading...
Need help?
General
