Tips for using Do Not Disturb
Cisco 7960/7940 Telephone User Guide System Telephone Features 43
620-05600070B
1. Enter your old 10-digit phone number, followed by the # key. You are
prompted to enter a password.
2. Enter the password, followed by the # key. (Your password is typically the last
four digits of your phone number.) The phone is now programmed back to its
original extension.
Do Not Disturb
Do Not Disturb instantly routes all your incoming calls to another destination (your
voice mailbox, the main operator, your secretary, a co-worker, etc.), but still lets
you make calls and use other telephone features. With Do Not Disturb enabled, the
phone will not ring when a call comes in.
When it is enabled, the display shows the extension followed by (DND).
Tips for using Do Not Disturb
You can record a special voice mail greeting for callers to hear if your calls go to
voice mail when you activate the Do Not Disturb feature. For more information, see
the appropriate section titled “Voice Mail Features” for your system.
The Do Not Disturb destination where incoming calls are sent can be changed by
your system administrator.
Enabling/Disabling Do Not Disturb
…using the Phone
To enable Do Not Disturb, press the Do Not Disturb (DnD) soft key.
To disable Do Not Disturb,re-press the Do Not Disturb (DnD) soft key.
…using Star Codes
The same star code is used to enable and disable Do Not Disturb since you are
switching between the on and off mode for this feature.
1. Press *04 on the telephone keypad.
2. Press the Dial soft key, or line or SPEAKER button, or pickup the handset.
3. Hang up the handset.
To Next Page
Loading...
Need help?
General
