Canceling a Meet-Me Conference
Cisco 7960/7940 Telephone User Guide System Telephone Features 53
620-05600070B
2. Press 1 to schedule a conference call.
3. Enter the two-digit year of the conference, followed by the # key.
4. Enter the two-digit month of the conference, followed by the # key.
5. Enter the two-digit day of the conference, followed by the # key.
The date must be within 365 days of the current date.
6. Enter the 4-digit start time of the conference call in 24-hour format (HHMM).
All start times must be in quarter hour increments (e.g., 0800, 0815, 0830,
0845)
7. Enter the length of the conference call in 5-minute increments, but with a
minimum of 15 minutes (e.g., 15, 20, 25, etc.) followed by the # key.
8. Enter the number of participants (conference ports to reserve) followed by the
# key.
The system repeats your conference call settings to you as “You have
requested to reserve a conference call for (day of week, date), at (time) with
a duration of (X) minutes and (X) ports.”
9. Press the # key if the information is correct, otherwise press 1 to re-enter the
conference call parameters.
NOTE: If you pressed # to accept the settings, the system speaks your conference call
meeting IDs including the Moderator ID, Guest ID, and the dial-in number.
Write down this information. It should also be displayed across your display
telephone.
10. Do one of the following:
• Press 1 to hear the information again, or
• Press * to return to the Meet-Me Conference setup menu, or
• Hang up.
Canceling a Meet-Me Conference
You may cancel a conference reservation at any time; however, conference
reservations are frozen 30 minutes before the start time and cannot be cancelled
after that time.
1. If dialing internally, dial the Meet-Me Schedule number (default is 523).
Otherwise, dial the ten-digit conference access number.
You may need to press the Dial softkey to complete dialing.
2. Press 2 to cancel a conference call.
3. Enter the Moderator ID of the conference you wish to cancel followed by the
# key.
To Next Page
Loading...
Need help?
General
