Cisco ASR 1000 Configuration Guide

15-6
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 15 Configuring the 8-Port Channelized T1/E1 SPA
Configuration Tasks
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Setting the IP Address
To set the IP address for the 8-Port Channelized T1/E1 SPA, complete these steps:
Verifying Interface Configuration
Use the show interfaces command to verify the interface configuration:
Router(config)# show interfaces
Serial6/0/1:0 is up, line protocol is up
Hardware is SPA-8XCHT1/E1
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
LCP Open, multilink Open
Last input 00:00:03, output 00:00:03, output hang never
Last clearing of "show interface" counters 5d17h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 3194905708
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
74223 packets input, 1187584 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
74227 packets output, 1187751 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
4 carrier transitions no alarm present
Timeslot(s) Used:1-24, subrate: 64Kb/s, transmit delay is 0 flags
Specifying the Interface Address on a SPA
SPA interface ports begin numbering with “0” from left to right. Single-port SPAs use only the port
number 0. To configure or monitor SPA interfaces, you need to specify the physical location of the SIP,
SPA, and interface in the CLI. The interface address format is slot/subslot/port, where:
Command Purpose
Step 1
Router(config)# interface serial
slot/subslot/port:channel-group
Selects the interface to configure and enters interface
configuration mode.
• slot/subslot/port:channel-group—Specifies the location of
the interface. See the
“Specifying the Interface Address on a
SPA” section on page 15-6.
Step 2
Router(config-if)# ip address
address mask
Sets the IP address and subnet mask.
• address—IP address.
• mask—Subnet mask.
Step 3
Router(config)# exit Exits interface configuration mode and returns to the EXEC
command interpreter prompt.

Cisco ASR 1000 Specifications

General

Brand	Cisco
Model	ASR 1000
Category	Network Router
Language	English