Cisco ASR 1000 Configuration Guide

CHAPTER
7-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
7
Configuring the ATM SPAs
This chapter provides information about configuring the ATM SPAs on the Cisco ASR 1000 Series
Aggregation Services Routers. It includes the following sections:
• Configuration Tasks, page 7-1
• Verifying the Interface Configuration, page 7-27
• Configuration Examples, page 7-28
For information about managing your system images and configuration files, refer to the following
publications:
• Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
• Cisco IOS XE Configuration Fundamentals Configuration Guide, Release 2.
For information about configuration of other features supported in the Cisco IOS XE software on the
Cisco ASR 1000 Series Routers, and the commands used in this chapter, see the
“Related
Documentation” section on page xxvi.
Configuration Tasks
This section describes the most common configurations for the ATM SPAs on Cisco ASR 1000 Series
Router. It contains procedures for the following configurations:
• Required Configuration Tasks, page 7-2
• Specifying the Interface Address on a SPA, page 7-4
• Modifying the Interface MTU Size, page 7-4
• Creating a Permanent Virtual Circuit, page 7-9
• Creating a PVC on a Point-to-Point Subinterface, page 7-11
• Configuring a PVC on a Multipoint Subinterface, page 7-13
• Configuring a Range of PVCs on a Multipoint Subinterface, page 7-15
• Configuring Traffic Parameters for PVCs, page 7-17
• Configuring Virtual Circuit Classes, page 7-20
• Configuring SONET and SDH Framing, page 7-21
• Configuring AToM VP Cell Mode Relay Support, page 7-23

Cisco ASR 1000 Specifications

General

Brand	Cisco
Model	ASR 1000
Category	Network Router
Language	English