Cisco ASR 1000 Configuration Guide

19-24
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 19 Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA
Configuration Tasks
To configure a BERT pattern for DS1/T1/E1, use one of the following commands:
Note In Cisco IOS XE Release 2.6, E1 is not supported on the 1-Port Channelized OC-12/STM-4 SPA.
To configure a BERT pattern for DS3/T3/E3, use the following command in controller configuration
mode:
Configuring QoS Features on Serial SPAs
The SIPs and SPAs support many QoS features using modular QoS CLI (MQC) configuration. Since
there are no serial SPA-specific QoS features, refer to your network processor documentation for QoS
configuration information.
Command Purpose
Router(config-controller)# t1 channel-number
bert pattern pattern interval time
or
Router(config-ctrlr-sts1)# e1 e1-number bert
pattern pattern interval time
Sends a BERT pattern on a line, where:
• channel-number—Number identifying the
specific T1 channel where you want to run
BERT.
• e1-number —Number identifying the specific
E1 channel where you want to run BERT.
• pattern—Specifies the type of repeating
BERT test pattern. Supported values are 0s,
1s, 1-in-8, 2^11, 2^15, 2^15-inverted, 2^20-
O.153, 2^20-QRSS, 2^23, 2^23-inverted, 2^9,
3-in-24, and alt-0-1.
• interval time—Specifies the duration of the
BERT test, in minutes. The range is 1 to
14400.
Command Purpose
Router(config-controller)# bert pattern {0s | 1s |
2^15 | 2^20 | 2^23 | alt-0-1} interval time
or
Router(config-ctrlr-sts1)# bert pattern {0s | 1s |
2^15 | 2^20 | 2^23 | alt-0-1} interval time
Sends a BERT pattern on the DS3 channel, where:
• interval time—Specifies the duration of the
BERT test, in minutes. The range is 1 to
14400.
Note See Table 19-2 for pattern descriptions.

Cisco ASR 1000 Specifications

General

Brand	Cisco
Model	ASR 1000
Category	Network Router
Language	English