Cisco ASR 1000 Configuration Guide

9
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Troubleshooting the SIP
Preparing for Online Insertion and Removal of the SIP and SPAs
Activation of a SIP Configuration Example
Activate a SIP if you have previously deactivated it. If you did not deactivate the SPAs, the SPAs
automatically reactivate with reactivation of the SIP.
The following example activates the SIP that is installed in slot 1 of the Cisco Aggregation Services
Router-1, its SPAs, and all of the interfaces (as long as the hw-module subslot shutdown command was
not issued to also deactivate the SPA):
Router(config)# hw-module slot 1 start
There are no corresponding console messages shown with activation using this command. If you re-enter
the hw-module slot start command, a message is displayed indicating that the module is already
enabled.
Deactivation of a SPA Configuration Example
Deactivate a SPA when you want to perform OIR of that SPA. The following example deactivates the
SPA (and its interfaces) that is installed in subslot 0 of the SIP located in slot 1 of the Cisco Aggregation
Services Router-1 and removes power to the SPA:
Router(config)# hw-module subslot 1/0 shutdown unpowered
Activation of a SPA Configuration Example
Activate a SPA if you have previously deactivated it. If you have not deactivated a SPA and its interfaces
during OIR of a SIP, then the SPA is automatically reactivated upon reactivation of the SIP.
The following example activates the SPA that is installed in subslot 0 of the SIP located in slot 1 of the
Cisco Aggregation Services Router-1:
Router(config)# no hw-module subslot 1/0 shutdown

Cisco ASR 1000 Specifications

General

Brand	Cisco
Model	ASR 1000
Category	Network Router
Language	English