Cisco cBR 8 User Manual

Table 18: Hardware Compatibility Matrix for the Cisco cBR Series Routers
Interface CardsProcessor EngineCisco CMTS Platform
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 CCAP Line Cards:
• PID—CBR-LC-8D30-16U30
• PID—CBR-LC-8D31-16U30
• PID—CBR-RF-PIC
• PID—CBR-RF-PROT-PIC
• PID—CBR-CCAP-LC-40G-R
Cisco cBR-8 Downstream PHY
Modules:
• PID—CBR-D30-DS-MOD
• PID—CBR-D31-DS-MOD
Cisco cBR-8 Upstream PHY
Modules:
• PID—CBR-D30-US-MOD
• PID—CBR-D31-US-MOD
Cisco IOS-XE Release 16.5.1 and
Later Releases
Cisco cBR-8 Supervisor:
• PID—CBR-SUP-250G
• PID—CBR-CCAP-SUP-160G
• PID—CBR-CCAP-SUP-60G
• PID—CBR-SUP-8X10G-PIC
Cisco cBR-8 Converged
Broadband Router
Prerequisites for Control Point Discovery
No special equipment or software is needed to use the Control Point Discovery feature.
Restrictions for Control Point Discovery
•
The CPD feature does not sync any dynamic CPD/NLS related data between the route processors (RPs).
After sending a NLS challenge to the controller, the new active PRE will ignore the NLS response as a
result of any RP switchover.
•
The CPEs become inaccessible for a small duration during line card switchovers. During this interval,
any CPD request received on CMTS will be responded to as if the endpoint is not connected or as if the
control relationship is not supported.
•
The CPD functionality is restricted to default VPN table id (0).
•
Only manual configuration of NLS authentication pass phrase would be supported for CPD/NLS security.
•
For NLS authentication, HMAC SHA1 (no configuration option) is used with MAC length truncated to
96 bits.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
98
Control Point Discovery
Prerequisites for Control Point Discovery

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English