Cisco cBR 8 User Manual

PurposeCommand or Action
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Enables NLS functionality.nls
Step 3
Example:
Router (config)# nls
•
NLS authentication is optional.
•
It is recommended that NLS message authentication be
enabled at all times.
Exits global configuration mode and enters privileged EXEC mode.end
Example:
Router# end
Step 4
Examples
The following example shows the nls command enbaled on a router.
Router (config)# nls
Debugging NLS Functionality
To debug the NLS feature, use the debug nls command in privileged EXEC mode. To disable debugging,
use the no form of this command.
Configuring Authorization Group Identifier and Authentication Key
The Authorization Group Identifier (AG ID) and corresponding authorization key are provisioned on CMTS,
as well as on controller/CPD requester.
To configure the Authorization Group Identifier and Authentication Key, use the nls ag-id command in global
configuration mode. It is recommended that NLS message authentication be enabled at all times.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration
Guide for Cisco IOS XE Fuji 16.8.x
104
Control Point Discovery
Debugging NLS Functionality

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English