Cisco cBR 8 User Manual

PurposeCommand or Action
Example:
Device(cfg-call-home)# ip-address
209.165.200.226
• ipv4/ipv6 address—Source IP (IPv4 or IPv6) address. Maximum
length is 64.
(Optional) Specifies the VRF instance to send call-home email messages.
If no vrf is specified, the global routing table is used.
vrfvrf-name
Example:
Device(cfg-call-home)# vrf vpn1
Step 8
For HTTP messages, if the source interface is associated with
a VRF, use the ip http client source-interface interface-name
command in global configuration mode. This command would
specify the VRF instance that is used for all HTTP clients on
the device.
Note
Specifying Rate Limit for Sending Call Home Messages
To specify the rate limit for sending Call Home messages, perform the following steps:
SUMMARY STEPS
1.
configure terminal
2.
call-home
3.
rate-limit number
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 1
Enters call home configuration mode.call-home
Example:
Device(config)# call-home
Step 2
Specifies a limit on the number of messages that are sent
per minute.
rate-limit number
Example:
Device(cfg-call-home)# rate-limit 40
Step 3
• number—Range 1 to 60. The default is 20.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
21
Call Home
Configuring Call Home

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English