cable helper-address 172.17.110.131
end
You can also use the more system:running-config command to verify the maximum number of permitted
CPE devices for a cable interface.
CMTS01# more system:running-config
Building configuration...
Current configuration:
!
interface Cable6/0
ip address 1.1.1.1 255.255.255.0
no keepalive
cable insertion-interval 2000
cable downstream annex B
cable downstream modulation 64qam
cable downstream interleave-depth 32
cable downstream symbol-rate 5056941
cable upstream 0 frequency 15008000
cable upstream 0 fec
cable upstream 0 scrambler
no cable upstream 0 shutdown
Additional References
For additional information related to configuring the MAX CPE and Host parameters on the Cisco CMTS,
refer to the following references:
Related Documents
Document TitleRelated Topic
Cisco CMTS Cable Command ReferenceCisco CMTS Commands
Using the max-cpe Command in the DOCSIS and
CMTS
Interaction of MAX CPE Parameters
Standards
TitleStandards
6
Data-Over-Cable Service Interface Specifications
Radio Frequency Interface Specification , version 1.1
( http://www.cablelabs.com/cablemodem/ )
SP-RFIv1.1-I08-020301
6
Not all supported standards are listed.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
225
Maximum CPE and Host Parameters
Additional References
To Next Page
Loading...
Need help?
General
