Cisco cBR 8 User Manual

What to Do Next
Once the IPDR session type is configured, only the templates supported by this IPDR type are allowed
be associated with it. Also, the console provides information about those templates that are not supported
by this IPDR session type when the type is changed.
Note
Configuring the IPDR Collector
To configure the IPDR collector details, use the ipdr collector command in global configuration mode. The
port number is used when an exporter creates an active connection.
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Enables the CMTS application to configure an IPDR collector and
authenticate the IPDR protocol.
ipdr collector
Example:
Router(config)# ipdr collector federal
Step 3
Configure the NAT address in case of an IPDR collector
that is operating in a NAT enabled network.
Note
192.168.6.5
Configuring the IPDR Associate
To associate the collector with a session, use the ipdr associate command in global configuration mode.
Before You Begin
•
You must deactivate the session before configuring the associate.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
for Cisco IOS XE Fuji 16.8.x
113
IPDR Streaming Protocol
Configuring the IPDR Collector

Cisco cBR 8 Specifications

General

Brand	Cisco
Model	cBR 8
Category	Network Router
Language	English