D-Link DGS-1210-10 User Manual

6 Command Line Interface D-Link Smart Managed Switch User Manual
146
DHCPv6 Client State : Disabled
DGS-1210-52MP>
show switch
Purpose To display the information of the Switch.
Syntax
show switch
Description
The show switch command displays the status of the switch.
Parameters None.
Restrictions None.
Example usage:
To display the switch information:
DGS-1210-52MP> show switch
System name :
System Contact :
System Location :
System up time : 0 days, 0 hrs, 12 min, 9 secs
System Time : 01/01/2016 00:10:30
System hardware version : F1
System firmware version : 6.00.005
System boot version : 1.00.003
System serial number : QBDES12105200
MAC Address : 4A-6F-6E-01-01-01
DGS-1210-52MP>
show route
Purpose To display the routing status of IPv4 or IPv6 on the Switch.
Syntax
show route {ipv4 | ipv6}
Description
The show route command displays the routing status of IPv4 or
IPv6 on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the IPv4 & IPv6 route status on the Switch:
DGS-1210-52MP> show route ipv4
IPv4 Static Route State : Disable

D-Link DGS-1210-10 Specifications

General

Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
MAC Address Table Size	8K
VLANs	256
Jumbo Frame	9, 216 bytes
Fanless Design	Yes
Humidity	5% to 95% non-condensing
Ports	8 x 10/100/1000Base-T, 2 x SFP
Dimensions	280 x 180 x 44 mm
Operating Temperature	0 to 40 °C
Storage Temperature	-40 to 70 °C