36 Using the System
6. Replace the topping foil cartridge.
a. Hold the cartridge by its handle.
b. Align the top of the cartridge with the
guides inside the embosser.
c. Slide the cartridge in until it clicks and
stops.
7. Close and lock the embosser supplies access
door.
Load the Cleaning Sleeve
The printer component uses a replaceable cleaning sleeve to remove dust and other particles
from cards before they travel into the printer. You should replace the cleaning sleeve when you
clean the printer, if you notice debris on the finished card, or if the cleaning sleeve is no longer
sticky.
1. Unlock the printer (and open
the printer supplies access door
on the multi-hopper).
The cleaning sleeve is accessible when the print ribbon cartridge is removed from
the printer.
Printer Supplies
Access Door
To Next Page
Loading...
Need help?
General
