Table 8. Interfaces to set up iDRAC IP address(continued)
Interface Documentation links
iDRAC Direct See the Integrated Dell Remote Access Controller User's Guide at https://
www.dell.com/idracmanuals. You can also go to https://www.dell.com/support
and search for your specific product in the Identify your product box.
NOTE: To determine the most recent iDRAC release for your platform and for
latest documentation version, see KB article https://www.dell.com/support/
article/sln308699.
Lifecycle Controller See the Dell Lifecycle Controller User's Guide or go to https://www.dell.com/
support and search for your specific product in the Identify your product box.
NOTE: To determine the most recent iDRAC release for your platform and for
latest documentation version, see KB article https://www.dell.com/support/
article/sln308699.
To access iDRAC, use one of the following:
● Connect the Ethernet cable to the iDRAC dedicated network port.
● Use the iDRAC Direct port by using a micro USB (type AB) cable.
If you have opted for a system in which shared LOM mode has been enabled, you can access iDRAC through the shared LOM
mode.
Log in to iDRAC
To log in to the iDRAC interface, open a browser and enter the IP address.
You can log in to iDRAC as:
● iDRAC user
● Microsoft Active Directory user
● LDAP user
From the login screen, if you have opted for secure default access to iDRAC, the default username is root. You can also enter
the iDRAC secure default password that is available on back of the Information Tag. The iDRAC default password is blank on the
Information tag.
If you opted for a legacy password, use the iDRAC legacy username and password - root and calvin. When prompted, enter
the wanted password to proceed. You can also log in by using your Single Sign-On or Smart Card. After setting up the iDRAC IP
address, verify that the default username and password have been changed.
For more information about logging in to iDRAC and iDRAC licenses, see the latest Integrated Dell Remote Access Controller
User's Guide. To determine the most recent iDRAC release for your platform and for latest documentation version, see KB
article https://www.dell.com/support/article/sln308699.
To access iDRAC using the RACADM command-line protocol, see the https://www.dell.com/idracmanuals. You can also access
iDRAC using Redfish API automation tool. For more information, see the Integrated Dell Remote Access Controller Users's Guide
Redfish API Guide.
Initial system setup and configuration
21
To Next Page
Loading...
Need help?
General