Digi Connect Series User Manual

Configurethedeviceusing theweb interface Alternativeconfiguration optionsfor Digi Connect Wi-SP
Digi Connect Family and ConnectPort TSFamily
126
6. Set the port settingsto 9600, 8, None, 1, None (default settings), click Apply and then click
OK.
7. Type thedefault user name, root, and the default password. The unique default password is
printed on the device label. If the password isnot on thedevice label, the default password is
dbps. If neither of the defaults work, the password may havebeen updated. Contact your
system administrator.
8. Usethe set wlan command to configure wireless network settings. Thiscommand isdescribed
in the Digi Connect and ConnectPort TSFamily Command Reference, available for download
from theDigi Support site and, for productsthat ship with aSoftware and Documentation CD,
on the CD.
9. After configuring the Digi Connect Wi-SPparameters to function within your network,
disconnect the power supply and the serial cable from the Digi Connect Wi-SP.
10. Reset the DIPswitch settings according to serial device requirements (EIA-232/422/485).
11. Connect the antenna and thepower supply to the Digi Connect Wi-SP.
12. Start the Digi Device Setup Wizard to discover and configure the Digi Connect Wi-SPfor your
network.
Note The Digi support website at www.digi.com/support providesadditional command resources.
Set DIP switchesexample
Set these DIPswitchesaccording to your serial device requirements (EIA-232/422/485).

Digi Connect Series Specifications

General

Brand	Digi
Model	Connect Series
Category	Network Router
Language	English