Configurethedeviceusing theweb interface AlarmsConfiguration
Digi Connect Family and ConnectPort TSFamily
99
Alarm Conditions
Usethe Alarm Conditionspage to specify the conditionson which the alarm is based, such as GPIO
pin state changes, serial data pattern matching, signal strength (RSSI), or data usage. Alarm
conditions include:
n
Send alarmsbased on GPIO pin states: Click thisradio button to specify that this alarm is
sent when thespecified GPIOpin states are detected. Then specify the following:
l
Pins: An alarm issent when thespecified combination of pin statesisdetected.
High - pin isasserted.
Low - pin isnot asserted.
Ignore - pin state is ignored.
l
Alarm recurrence time: Defineshow often to send a new alarm. For example, if the alarm
recurrence time is10 secondsthen even if the pin statesare detected 5 timeswithin a 10
second period only one alarm will be sent.
l
Send reminderswhile GPIO pinsremain in thisstate: If enabled, reminderswill be sent
if the pins remain in the defined state for an extended period of time.
l
Every: The number of secondsthe pins must remain in the defined state for a reminder to
be sent.
n
Send alarmsbased on serial data pattern matching: Click this radio button to specify that
thisalarm is sent when the specified serial data pattern isdetected. Then specify the following:
l
Serial Port: The serial port to monitor for the data pattern. This field appearsfor devices
where more than oneserial port isavailable.
l
Pattern: When theserial port receives this data pattern it sends an alarm. You can include
special characters such as carriage return carriage return (\r) and new line (\n) in the data
pattern.
Alarm Destinations
Usethe Alarm Destinations page to definehow alarm notificationsare sent, either as an email
message or an SNMPtrap, or both, and where the alarm notification issent.
n
Send E-mail to the following recipientswhen alarm occurs: Enable sending the alarm asan
email message. Then specify the following information:
l
To: The email addressto which thisalarm notification email message will be sent.
l
CC: The email addressto which a copy of this alarm notification email message will be sent
(optional).
l
Priority: The priority of the alarm notification email message.
l
Subject: The text to be included in the Subject: line of the alarm-notification email.
To Next Page
Loading...
Need help?
General
