Overview: Configuration, monitoring, and administration Web interface
Digi Connect Family and ConnectPort TSFamily
39
n
Maintaining high levelsof security
n
Provisioning and decommissioning of equipment
n
Adding functionality to device networks
Additionally, you can group devicestogether, schedulevariousoperations, and set alarm
notifications. For example, you can set an alarm to send a notification if a device disconnectsor
remainsconnected longer than a specified period.
Some thingsto note about using Remote Manager:
n
Devices must be registered in a Remote Manager account beforeyou can access them.
n
To minimize network traffic, Remote Manager usescaching. Asa result, device settingscan be
out-of-sync between the device and the settings viewed on the console.
n
Device information refreshes on demand when the device is connected, and refreshes
automatically when a device connects.
For more information on Remote Manager as a remote device network management solution, see
these resources:
n
Remote Manager User Guide
n
Remote Manager Programmer Guide
n
Remote Manager tutorialsand other documents available on Digi'sKnowledge Base
Web interface
Digi Connect and ConnectPort TSFamily devicesprovide a web interface for configuring and
monitoring devices. See Using the Digi Connect and ConnectPort TSFamily web interface.
You are required to log in to theweb interface.
n
User name: The default user name isroot.
n
Password: The unique default password isprinted on thedevice label. If the password is not
on the device label, the default password is dbps.
If the default user name and password doesnot work, they may havebeen updated. Contact your
system administrator. You are required to change the password from the default the first timeyou log
into the web interface.
Note Not all configuration optionsprovided by thecommand-line interface (CLI) appears in the web
interface. If you need to configure more advanced options, see the Accessing the command-line
interface for instructionson accessing the CLI.
Accessing the command-line interface
You can configure Digi devices by issuing commandsfrom the command line. The command-line
interface allows direct communication with a Digi device.
To accessthe command linefrom the Digi Device Discovery utility, click Telnet to command line.
For example, you can issue the following command from the command line to set general serial
configuration options:
#> set serial baudrate=9600 flowcontrol=hardware
To Next Page
Loading...
Need help?
General
