Digi Connect Series User Manual

Configureand managethedeviceusing theDigi Connect and ConnectPort TSFamily
command lineinterface
Administration
Digi Connect Family and ConnectPort TSFamily
137
set tcpserial
Usethe set tcpserial command to configure serial TCP.
set udpserial
Usethe set udpserial command to configure the serial UDP.
set user
Usethe set user command to configure a user.
set wlan
Usethe set wlan command to configure wireless devices.
set wlan
Usethe set wlan command to configure wireless devices.
status
Usethe statuscommand to display a list of sessionsor outgoing connections made by the connect,
rlogin, or telnet commandsfor a Digi device. Usethe statuscommand to determine which of the
current sessionsto close.
show
Usethe show commands to display current settings on a Digi device.
telnet
Usethe telnet command to establish an outgoing telnet connection, also known asa session.
who and kill
Usethe who command to display a global list of connections. The list of connections includesthose
associated with a serial port or the command-line interface.
Usethe kill command to terminate active connections based on the ID number returned from the
who results.
Usethe who command to determine any connections that are no longer needed, and end the
connectionsby issuing a kill command.
Administration
You can issue commandsfrom the command-lineinterface to administer Digi Connect and
ConnectPort TSFamily products. Thefollowing table displaysseveral administration tasksand the
commandsused to perform them. See the Digi Connect®Family Command Reference for more
complete command descriptions.

Digi Connect Series Specifications

General

Brand	Digi
Model	Connect Series
Category	Network Router
Language	English