Configureand managethedeviceusing theDigi Connect and ConnectPort
TSFamily command lineinterface
Management through the
command lineinterface
Digi Connect Family and ConnectPort TSFamily
133
n
Active TCPsessionsand active TCPlisteners(display tcp).
n
Current UDPlisteners(display udp).
n
Uptime information (display uptime).
exit and quit
Usethe exit and quit commandsto terminate a currently active session.
flashdrv
Usethe flashdrv command to accessthe Memory Module connected to the USB port on the
ConnetPort TS8/16 and view the available memory size.
info
Usethe info commands to display statistical information about a device over time. The statistics
displayed are those gathered since the tables containing the statistics were last cleared. The typeof
statistics include:
n
Device statistics. The info device command displays such detailsasproduct, MACaddress,
boot, POST, and firmware versions, memory usage, utilization, and uptime.
n
Ethernet statistics. The info ethernet command displaysstatistics regarding theEthernet
interface, including:
l
Thenumber of bytes and packets sent and received
l
Thenumber of incoming and outgoing bytesthat werediscarded or that contained errors
l
Thenumber of Rx overruns
l
Thenumber of timesthe transmitter was reset
l
Thenumber of incoming bytes when the protocol was unknown
n
ICMPstatistics. Theinfo icmp command displaysthe number of messages, bad messages, and
destination unreachable messages received.
n
Serial statistics. The info serial command displaysthe following information:
l
Number of bytes received and transmitted
l
Signal changes
l
FIFOand buffer overruns
l
Framing and parity errors
l
Breaksdetected
To Next Page
Loading...
Need help?
General
