MAINTENANCE AND FAULT FINDING
5-6 L025317 Issue 1 March 2011
8 Print go while
DSP data not
ready
A new print is
currently being
compiled and no
print start can be
issued until the
printer is ready again.
Monitor 'compile OK' line
high when data compiled and
make sure that you don't
trigger a print before it is high
again after a data change
10 DSP list buffer
empty.
There is no data
available for the next
print.
Coding file is at the last item,
or data from external
controller is late.
11 Encoder/Line too
fast (overflow).
The message has not
been completed in
time.
Slow down the conveyor,
reduce the mark time, or
move the text upstream on the
field.
12 Encoder/Line too
slow (underflow.)
The message has not
been completed in
time.
Reduce the mark time or
move the text upstream on the
field.
13 List buffer repeat
count fail.
Internal Fault. Restart the system, re-store
backup. Contact Domino.
14 Maximum print
to print distance
exceeded.
The maximum
distance between
print go signals has
been exceeded and an
expected print go was
not received.
Check the sensor is set up
correctly, disable this function
if the check is not needed.
15 Print start signal
ignored.
A print go has been
received too soon
after the previous.
Check for switch bounce on
the print go, check for a
correctly set up sensor.
16 Maximum laser
on time exceed
(laser disabled by
hardware).
The laser has been
firing for longer than
expected.
Contact Domino.
17 Laser warm up. The laser needs a
short warm up period
before it can be used.
Wait until this warning goes
off before using the laser.
30 Scanhead power
missing.
There is no +/-15v at
the scanhead, or no
data returning from
scanhead.
Check connections to the
print head.
Status Message Cause Suggested Action
To Next Page
Loading...
Need help?
General