INSTALLATION
L025317 Issue 1 March 2011 2-3
UNPACKING AND INVENTORY
Prior to and while unpacking the control unit and laser assembly, visually
check for damage that has occurred during transportation, in particular; loose
parts, dents, scratches and missing parts.
ASSEMBLY
Before assembly, check the laser head and control unit for visible damage.
Refer to PART 1 : “HEALTH & SAFETY” .
The installation of the laser marking systerm has to comply to IEC 60825-1.
Environmental Conditions
The following conditions are necessary for operation of the laser marking
system:
The controller is capable of operating within the International Protection
Code IP43, which provides dust protection and protection from splashing
water. To protect the installation from more severe conditions, extra measures
must be taken.
Handling the Equipment
The equipment must be handled appropriately and carefully. The laser head
must not be held by the scanner head or by the supply lines. The control unit
is to be specifically protected during assembly.
CAUTION: The assembly, i.e. the mounting and the
installation of the laser marking system must
only be performed by personnel qualified for this
task and in accordance with the valid regulations
and safety instructions.
Temperature +5°C to +40°C
90% max relative humidity - non-condensing
To Next Page
Loading...
Need help?
General