INSTALLATION
2-4 L025317 Issue 1 March 2011
Laser Head Assembly
The laser head must be mounted correctly on the support profile provided for
this purpose (depending on the used laser system).
A mechanical de-coupler must be provided to prevent damage to the laser
head, or its mounting, during shock or shaking motions of the packaging
machine.
The lens opening must be centred vertically over the text field of the object to
be marked.
Correct laser marking is only possible, when the surface of the object is at the
focal point of the lens.
The distance "a" is measured from the scanner head to the object.
The required measurement “a” is marked on the individual lens, and should
be noted before installing the equipment.
Removal of the transport locking device
CAUTION: The beam output lens is protected by a transport
locking and dust protection cap, to prevent
damage or external soiling that will cause a
reduction in laser performance. Remove this
device without fail before operation.
Scanner Head
Lens
Object to be Marked
a
To Next Page
Loading...
Need help?
General