WARNINGS:
AS SUPPLIED, THIS CODER IS A CLASS 4 LASER PRODUCT.
DURING OPERATION, IT WILL EMIT UP TO 100 WATTS OF
PULSED INVISIBLE LASER RADIATION AT A WAVELENGTH
BETWEEN 9 AND 11 MICRONS. AVOID EYE OR SKIN
EXPOSURE TO DIRECT OR SCATTERED RADIATION.
THIS CODER MUST BE FITTED WITH CLASS 1 LASER
GUARDING TO SAFEGUARD AGAINST ACCIDENTAL
EXPOSURE TO DIRECT OR SCATTERED RADIATION BEFORE
IT IS OPERATED OR MADE READY FOR USE.
GUIDANCE ON CREATING AND FITTING LASER GUARDING
CAN BE FOUND IN PART 1 OF THE PRODUCT MANUAL.
USE OF CONTROLS OR ADJUSTMENTS OF PERFORMANCE
OR PROCEDURES OTHER THAN THOSE SPECIFIED IN THIS
MANUAL MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
THE LASER PRINT HEAD (D120 IP, D320 IP) IS COOLED BY
COMPRESSED AIR. OVERPRESSURE INSIDE THE LASER
PRINT HEAD CAN DAMAGE THE PRINTER CABINET AND LEAD
TO PERSONAL INJURY.
THE MAXIMUM PRESSURE FOR THE COMPRESSED AIR
SUPPLIED INTO THE PRINT HEAD IS 3.5 BAR. THIS PRESSURE
MUST NOT BE EXCEEDED AT ANY TIME.
THE LASER PRINT HEAD HAS TWO AIR OUTLETS. BOTH AIR
OUTLETS MUST BE KEPT CLEAR AS BLOCKED AIR OUTLETS
CAN CAUSE OVERPRESSURE INSIDE THE PRINT HEAD.
THE COMPRESSED AIR MUST BE FREE OF OIL (CLASS 1.7.2
OF ISO 8573).
DO NOT SWAP THE AIR INLET AND OUTLET. THE LENGTH OF
THE COMPRESSED AIR OUTLET HOSE MUST NOT EXCEED 4M
To Next Page
Loading...
Need help?
General