Duplo DBM-600T User Manual

1-11
Chapter 1 Before Operation
No. Name Function
[1] Stopper angle xing knob Loosen when adjusting the stopper angle adjustment.
(p.2-43)
[2] Stopper angle adjustment Adjusts the angle of the stopper.
(p.2-43)
[3] Conveyance belt Conveys a booklet. The height is automatically adjusted according
to the number of sheets in the booklet.
[4] Press angle unit Weakens pressure of the press bar against a booklet. Use this when
a booklet is torn by a stitch.
(p.2-44)
[5] Press bar Holds a booklet when trimming a booklet.
[6] Stopper Stops a booklet at the trimming position.
(p.2-25)
[7] Infeed sensor height adjustment knob
screw
Adjusts the height of the infeed sensor.
(p.2-45)
[8] Ocut ejection air Ejects ocuts, which are left after booklets are trimmed, into the
scrap box.
[9] Duct unit Sends ocuts ejection air to the knife section. Remove the duct
unit when paper jams under the infeed roller unit.
[10] Knife section Trims the fore-edge of a booklet.
(p.5-8)
[11] Infeed roller unit Sends booklets conveyed from the upstream unit to the inside the
machine.
(p.5-9)
[12] Support roller knob screw Used to change the position of the support rollers. When the
infeed roller unit has been raised using the infeed roller unit knob
screw, short booklets may stop under the infeed roller unit. In that
case, move the support roller knob screw downward to lower the
support rollers.
(p.2-19)
[13] Infeed roller adjustment Adjusts holding pressure of the infeed roller unit against a booklet.
(p.2-42)
[14] Infeed roller unit knob screw Used to raise the infeed roller unit. When the trimming width is
25 mm/0.98 inch or more, raise the infeed roller unit so that the
support rollers do not touch a booklet.
(p.2-19)
[15] Infeed roller Sends a booklet conveyed from the upstream unit to the inside of
the machine.
[16] Ejection roller Ejects a booklet to the downstream unit.

Duplo DBM-600T Specifications

General

Brand	Duplo
Model	DBM-600T
Category	Folding Machines
Language	English