2-45
Chapter 2 Basic Operation
9-5. Adjusting the infeed sensor height
When a booklet is not detected, lower the infeed sensor.
Standard position: upper
1
Loosen the infeed sensor height
adjustment knob screw.
2
Lower the infeed sensor height
adjustment knob screw.
3
Tighten the infeed sensor height
adjustment.
9-6. Preparing for the loop stitching
Fire, electrication, injury,
malfunction, or breakdown may
be caused by disassembling the
parts which are not specied in
this manual.
Do not disassemble the
product more than needs.
• Do not use the L-wrench for purposes other than instructed in this manual.
• Before following the procedures below, turn off the power switch of this machine referring
to the procedures in ”1-2. Turning off the power”
(p.2-2)
and disconnect the power cords of this
machine from the wall outlet.
If you want to perform loop stitching, contact your dealer.
Before performing loop stitching, change the position of the slide stopper following the procedures below.
1
Loosen the fixing screws of the slide
stopper using the supplied L-wrench.
2
Move the fixing screws inward until
they stop.
The slide stoppers will close completely.
3
Tighten the fixing screws of the slide
stopper using the supplied L-wrench.
To Next Page
Loading...
Need help?
General
