12Installation and Service Guide: Color Controller E-46A
Introduction
• E-46A documentation, including the customer media pack and any related service bulletins
Precautions
This section includes information about how to safely operate and service the E-46A and how to avoid damage to E-
46A components.
Report shipping damage
If there is evidence of shipping damage, save the shipping boxes and damaged parts. Call the shipper immediately to
file a claim and notify your authorized service/support center.
Do not change an existing network
The E-46A is probably connected to an existing Local Area Network (LAN) based on Ethernet hardware. The network
is the link between the customer’s computer, existing laser printers, and other prepress equipment. Never disturb the
LAN by breaking or making a network connection, altering termination, installing or removing networking hardware
or software, or shutting down networked devices without the knowledge and express permission of the site
administrator.
Do not assign an IP address to the E-46A
Only the site administrator should assign an IP address to a network device, including the E-46A. If you enter an
incorrect IP address for the E-46A, errors may occur on connected devices.
Handling the boards
When handling a printed circuit board, do not bend it. Hold it by opposing edges, rather than by the corners.
Handling the hard disk drive
To ensure that you do not damage the hard disk drive, do the following:
• Follow electrostatic discharge (ESD) precautions.
• Keep magnets and magnetic-sensitive objects away from the hard disk drive.
• Do not loosen or remove the screws on the top of the hard disk drive. Doing so voids the warranty.
• Handle the hard disk drive by its sides and avoid touching the printed circuit board.
• Do not drop, shake, or bump the hard disk drive.
• Before you remove or install a hard disk drive, allow it to reach room temperature.
Avoid magnets
Keep magnets and magnetic-sensitive objects away from electronic components, especially the hard disk drive.
Avoid touching magnetic tools to storage media such as hard disk drive. Contact between
magnetic tools and magnetic storage media may result in data corruption.
To Next Page
Loading...
Need help?
General
