Enterasys SecureStack C2 C2G170-24 User Manual

set spantree maxage
SecureStack C2 Configuration Guide 9-19
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtogloballyresettheSpanningTreehellotime:
C2(su)->clear spantree hello
set spantree maxage
Usethiscommandtosetthebridgemaximumagingtime.
Syntax
set spantree maxage agingtime
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thebridgemaximumagingtimeisthemaximumtime(inseconds)adevicecanwaitwithout
receivingaconfigurationmessage(bridge“hello”)beforeattemptingtoreconfigure.Alldevice
ports(exceptfordesignatedports)shouldreceiveconfigurationmessagesatregularintervals.
AnyportthatagesoutSTPinformationprovidedinthelast
configurationmessagebecomesthe
designatedportfortheattachedLAN.Ifitisarootport,anewrootportisselectedfromamong
thedeviceportsattachedtothenetwork.
Example
Thisexampleshowshowtosetthemaximumagingtimeto25seconds:
C2(su)->set spantree maxage 25
clear spantree maxage
UsethiscommandtoresetthemaximumagingtimeforaSpanningTreetothedefaultvalueof20
seconds.
Syntax
clear spantree maxage
agingtime Specifiesthemaximumnumberofsecondsthatthesystemretainsthe
informationreceivedfromotherbridgesthroughSTP.Validvaluesare6‐
40.

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English