Enterasys SecureStack C2 C2G170-24 User Manual

Configuring 802.1X Authentication
SecureStack C2 Configuration Guide 23-11
Configuring 802.1X Authentication
Purpose
Toreviewandconfigure802.1XauthenticationforoneormoreportsusingEAPOL(Extensible
AuthenticationProtocol).802.1Xcontrolsnetworkaccessbyenforcinguserauthorizationon
selectedports,whichresultsinallowingordenyingnetworkaccessaccordingtoRADIUSserver
configuration.
Commands
show dot1x
Usethiscommandtodisplay802.1Xstatus,diagnostics,statistics,andreauthenticationor
initializationcontrolinformationforoneormoreports.
Syntax
show dot1x [auth-diag] [auth-stats] [port [init | reauth]] [port-string]
Parameters
Defaults
Ifnoparametersarespecified,802.1Xstatuswillbedisplayed.
Note: To configure EAP pass-through, which allows client authentication packets to be forwarded
through the switch to an upstream device, 802.1X authentication must be globally disabled with the
set dot1x command (“set dot1x” on page 23-14).
For information about... Refer to page...
show dot1x 23-11
show dot1x auth-config 23-13
set dot1x 23-14
set dot1x auth-config 23-15
clear dot1x auth-config 23-16
show eapol 23-17
set eapol 23-19
clear eapol 23-19
auth‐diag (Optional)Displaysauthenticationdiagnosticsinformation.
auth‐stats (Optional)Displaysauthenticationstatistics.
portinit|reauth (Optional)Displaysthestatusofportinitializationandreauthentication
controlfortheport.
port‐string (Optional)Displaysinformationforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
in
theCLI”onpage 7‐2.

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English