Enterasys SecureStack C2 C2G170-24 User Manual

ip address
SecureStack C2 Configuration Guide 19-5
ip address
Usethiscommandtoset,remove,ordisableaprimaryorsecondaryIPaddressforaninterface.
ThenoformofthiscommandremovesthespecifiedIPaddressanddisablestheinterfaceforIP
processing.
Syntax
ip address ip-address ip-mask [secondary]
no ip address ip-address ip-mask
Parameters
Defaults
Ifsecondaryisnotspecified,theconfiguredaddresswillbetheprimaryaddressfortheinterface.
Mode
Routerinterfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Usage
EachSecureStackC2systemsupportsupto24routinginterfaces,withupto8secondary
addressesallowedforeachprimaryIPaddress.
Example
ThisexamplesetstheIPaddressto192.168.1.1andthenetworkmaskto255.255.255.0forVLAN1:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip address 192.168.1.1 255.255.255.0
Outgoing Access
List
Not supported.
MTU Interface’s Maximum Transmission Unit size.
ARP Timeout Duration for entries to stay in the ARP table before expiring. Set using the arp
timeout command as described in “arp timeout” on page 19-11.
Direct Broadcast Whether or not IP directed broadcast is enabled. Set using the ip directed-broadcast
command described in “ip directed-broadcast” on page 19-12.
Proxy Arp Whether or not proxy ARP is enabled or disabled for this interface. Set using the ip
proxy arp command as described in “ip proxy-arp” on page 19-10.
Table 19-1 show ip interface Output Details (Continued)
Output Field What It Displays...
ip‐address SpecifiestheIPaddressoftheinterfa c etobeaddedorremoved.
ip‐mask Specifies themaskfortheassociatedIPsubnet.
secondary (Optional)SpecifiesthattheconfiguredIPaddressisasecondaryaddress.

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English