Enterasys SecureStack C2 C2G170-24 User Manual

Configuring IGMP on Routing Interfaces
13-10 IGMP Configuration
Configuring IGMP on Routing Interfaces
Purpose
ToconfigureIGMPonroutinginterfaces.
Commands
ip igmp
UsethiscommandtoenabletheL3IGMPQuerierfunctionalityontheswitch.Thenoformofthis
commanddisablesIGMPQuerierfunctionality.
Syntax
ip igmp
no ip igmp
Parameters
None.
Defaults
None.
Mode
Globalconfiguration:C2(su)‐>router(Config)#
Router: The commands covered in this section can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 18-2.
For information about... Refer to page...
ip igmp 13-10
ip igmp enable 13-11
ip igmp version 13-11
show ip igmp interface 13-12
show ip igmp groups 13-13
ip igmp query-interval 13-13
ip igmp query-max-response-time 13-14
ip igmp startup-query-interval 13-14
ip igmp startup-query-count 13-15
ip igmp last-member-query-interval 13-15
ip igmp last-member-query-count 13-16
ip igmp robustness 13-16

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English