SecureStack C2 Configuration Guide 18-1
18
Preparing for Router Mode
Thischapterdescribeshowtopreparetheswitchforrouting.
Pre-Routing Configuration Tasks
StartupandgeneralconfigurationoftheSecureStackC2switchmustoccurfromtheswitchCLI.
Fordetailsonhowtostarttheswitchandconfiguregeneralplatformsettings,refertoChapter 1,
Introduction,Chapter 2,ConfiguringSwitchesinaStack,andChapter 3,BasicConfiguration.
Oncestartupandgeneralswitchsettings
arecomplete,IPconfigurationandotherrouter‐specific
commandscanbeexecutedwhentheswitchisinroutermode.Fordetailsonhowtoenablerouter
modefromtheswitchCLI,refertoTable 18‐2inEnablingRouterConfigurationModes.
Thefollowingpre‐routingtasksmustbeperformedfromtheswitch
CLI:
•StartinguptheCLI.(“UsingtheCommandLineInterface”onpage1‐6)
•Settingthesystempassword.(“setpassword”onpage3‐5)
• Configuringbasicplatformsettings,suchashostname,systemclock,andterminaldisplay
settings.(“Setting BasicSwitchProperties”onpage3‐9)
•Settingthesystem
IPaddress.(“setipaddress” onpage3‐11)
• CreatingandenablingVLANs.(Chapter 10)
•Filemanagementtasks,includinguploadingordownloadingflashortextconfigurationfiles,
anddisplayingdirectoryandfilecontents.(“ManagingSwitchConfigurationandFiles”on
page3‐37)
• Configuringtheswitchtoruninroutermode.
(“EnablingRouterConfigurationModes”on
page18‐2)
•Enablingadvancedrouterfeatures.(“Ac tiva tingAdvancedRoutingFeatures”onpage20‐1)
For information about... Refer to page...
Pre-Routing Configuration Tasks 18-1
Enabling Router Configuration Modes 18-2
Note: The command prompts used as examples in Table 18-1 and throughout this guide show
switch operation for a user in admin (su) access mode, and a system where the VLAN 1 interface
has been configured for routing. The prompt changes depending on your current configuration
mode, your specific switch, and the interface types and numbers configured for routing on your
system.
To Next Page
Loading...
Need help?
General