Epygi QX series Administrator's Guide

QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x) 32
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
General Operation Mode
The
General Operation Mode
page provides the option of setting up a
corresponding mode for the QXFXS24 gateway.
The General Operation Mode radio buttons are as follows:
• The Stand-alone mode selection configured the device manually
from its own GUI. In this mode the device is used as a standalone
gateway.
• The PNP Mode selection getting the device configuration from
another QX IP PBX unit. Some configuration values could be
altered manually if needed.
Fig.II- 33: QXFXS24 General Operation Mode page
FXS Lines
FXS (On-board) Line Settings
The FXS (On-board) Line Settings page is used to configure QX lines and to define the caller ID detection type, configure remote party disconnect
indication and select the ringer type on each of them. Additionally this page provides an option to enable Loopback diagnostics on the lines.
The
Onboard Line Settings
page shows the table
Available Lines
where all active lines of QX are listed (QXFXS24 has 24 active lines)
with their Attached Extension. If the line is attached to an extension,
the corresponding extension number is displayed in this column;
otherwise “none” is displayed if the extension is not attached to the
line. By clicking on the extension number, the
Extensions Management
- General Settings page will appear, where the line attached to the
extension can be reconfigured. Additionally, the ta
ble provides
information about the selected Ringer Type and Caller ID detection
method that is configured for the selected line. The caller ID detection
method is different for various types of phones and can be found in the
phone manual.
When pressing on the line number under the Available Lines column
,
the FXS On-board Line Settings page specific for the current line is
opened and offers the following input options:
Fig.II- 34: FXS Line page
The
Caller ID
drop down list contains various standards of Caller ID
transmissions. It is used to send the calling party's information to the
phone attached to the selected line:
• No Caller ID.
• FSK, send prior to the first ring.
• FSK, send between the first and second ring.
• FSK, send both prior to a ring and between the first and second
ring.
• DTMF, send prior to the first ring.
• DTMF, send between the first and the second ring.
• Combined, send both DTMF prior to the first ring and FSK
between the first and the second rings.
The QX sends the current time/date to the called phone together with
the caller’s information.
Fig.II- 35: Line Settings – Line# page

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English