Epygi QX series Administrator's Guide

QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x) 86
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
IP Routing Configuration
Routing is used to relay information across the Internet from a source to a destination. Along the way, at least one intermediate node is typically
encountered. Routing is different than bridging. The main difference between bridging and routing is that bridging operates at the OSI Data Link Layer
(Level Two Media Access Control Layer) and routing operates at OSI Network Layer (Level Three).
QX gateway’s IP Routing service allows you to route IP packets from one destination to another (or to a specified router) through QX gateway or a QX
gateway VPN.
The IP Routing page is used to make IP Static, IP Policy and PPTP/L2TP routes for IP packets routing. This page consists of three tables. Entries in the
tables are color coded according to the state of the route. For example, yellow indicates disabled routes, green indicates successful routes and red
indicates routes with an error.
IP Static Routes
IP Static Routes
are used to forward IP packets from the Network,
where the QX IP PBX is connected, to the specified destination.
The IP Static Routes table displays all established IP static routes
with their parameters: Target State for the state of the route
(enabled or disabled), Actual State for the state of the route
connection (up, down or erroneous), Route To for the subnet where
the incoming packets should be routed to and Via IP Address for the
router IP address where incoming packets should be routed through.
Add opens the Add IP Static Route page where a new static route
can be established.
Enable/Disable is used to activate and deactivate a selected
route(s). At least one route should be selected in order to use these
functions, otherwise the following error message will appear: “No
record(s) selected.”
Fig.II- 122: IP Static Routes table
The
Add IP Static Route
page offers the following components:
Route To requires the IP address and subnet mask for the
destination the IP packet should be forwarded to.
Via IP Address requires the IP address of the subsequent router for
IP packet forwarding to the specified destination.
Attention: The rule with the longest subnet (smallest IP range) will
take effect when having two or more IP Static routing rules with the
coinciding subnets.
Fig.II- 123: Add IP Static Route page
IP Policy Routes
IP Policy Routes allow IP packets forwarding to the specified router depending on the source IP address as well as defining the priority for the current
routing rule.
The
IP Policy Routes
table displays all specified IP policy routes
with their parameters:
Target State
for the state of the route
(enabled or disabled), Actual State for the state of the route
connection (up, down or erroneous), Priority for the route priority,
Route From is where the subnet, routed packets come from and Via
IP Address is where the router IP address incoming packets should
be routed through.
Add opens the Add IP Policy Route page to establish a new policy
route.
Enable and Disable are used to activate or to deactivate the selected
route(s).
Fig.II- 124: IP Policy Routes table
Raise Priority and Lower Priority are used to increase or decrease the priority of the selected policy route(s) by one. At least one route should be
selected to use these functions, otherwise the error message “No record(s) selected” will appear.

Epygi QX series Specifications

General

Brand	Epygi
Model	QX series
Category	PBX
Language	English