Chapter 6 General
6.4 Service Mode
6-34
IOT Diag
Digital Input
Checks whether the DI (digital input) components such
as sensors and switches on the IOT are functioning
properly.
6.6.1
Digital Output
Checks whether the DO (digital output) components
such as motors and clutches are functioning properly.
6.6.2
NVM
Settings
Edit NVM
Reads and writes the content of the NVM of the IOT for
the Chain Link specified.
6.6.3
Save NVM to
ESS
Saves the IOT NVM information to the ESS NVM.
Load NVM
from ESS
Loads the information saved in the ESS NVM to the IOT
NVM.
(If [Save NVM to ESS] has never been executed, no
NVM backup data is stored, and therefore this item is
not displayed.)
ROS Exposure Corrects the variation in the Lead-Regi of the ROS. 6.6.4
Dew Prevention Sets whether to enable the Dew Prevention mode. 6.6.5
ATC Mode
Sets whether to enable the ATC (Automatic Toner Con-
trol) empty detection mode.
ON: Changes the toner cartridge detection method to
the count method.
OFF: Changes the toner cartridge detection method to
the ATC method.
6.6.6
Print Info
Config Page
Prints the printer configuration information. (Available
print size is A4.)
6.7.1
Print Settings
Prints the printer setting information. (Available print
size is A4.)
6.7.2
Table 6-28 Function Names and Descriptions (Printer Diag)
Function Description See
To Next Page
Loading...
Need help?
General
