▶
Save and close the definition file.
▶
For the changes to take ef
fect, you need to reboot the network by entering
the following command:
# service network restart
If the system board or network controller offers multiple LAN ports, it
is necessary to update the remaining ifcfg-eth<x> definition files
accordingly
.
▶
Update the NIC configuration file to reflect the new card sequence and MAC
address.
5.2.7 Resuming BitLocker functionality
If BitLocker Drive Encryption has been suspended for maintenance purposes
(see "Suspending BitLocker functionality" on page
61), it has to be reenabled
to complete the service task.
If BitLocker Drive Encryption has been suspended prior to replacing
components you won't be asked for a recovery key when rebooting the
server after the maintenance task. However, if BitLocker functionality
has not been suspended, Windows will enter recovery mode and ask
you to input recovery key for further booting.
▶
In this case, ask the system administrator to enter the recovery key in
order to boot the operating system.
▶
Ask the system administrator to suspend BitLocker-protection on the system
volume, using the BitLocker Drive Encryption control panel item.
For Windows Server 2008
▶
Click Start
- Control Panel - Security - BitLocker Drive Encryption to
open the BitLocker Drive Encryption.
▶
Select the system volume, and click Turn On BitLocker.
Basic software procedures
68 Upgrade and Maintenance Manual TX1310 M5
To Next Page
Loading...
Need help?
General