GE Dash 3000 Operator's Manual

Monitoring Temperature
2000966-386D Dash™ 3000/4000/5000 14-3
NOTE
All changes are temporary and revert to the factory or custom defaults when the
patient is discharged. To permanently change the these settings, refer to Defining
Custom Defaults on page 3-7.
Troubleshooting
Option Function
T1 Select the T1 temperature site to acquire patient data. When
off, no patient data is acquired or displayed.
T2 Select the T2 temperature site to acquire patient data. When
off, no patient data is acquired or displayed.
UNITS Select the unit of measurement.
TEMPERATURE LIMITS Select the high and low alarm limits for each temperature
site. An alarm sounds when a value occurs outside of these
limits.
Message Cause Solution
CAL CHECK The monitor detects a 0.1ºC deviation
between the temperature value and the
internal calibration.
Check the sensor.
CAL FAIL
SENSOR The monitor does not detect a sensor.

GE Dash 3000 Specifications

General

Brand	GE
Model	Dash 3000
Category	Monitor
Language	English